Great Plains Smartbox Mount Kit Yield Pro Planters - Manual (Page 14)

Great Plains Mfg., Inc.
14 Smartbox® Mount Kit
403-206M 12/12/2006
Mount Wing Box Frames
(all Models)
Mounting wing box frames does not have the same con-
siderations as for frames near or at center. There is
some additional flexibility in placement on the tubes, so
review where each is to go. it might be useful to mark
the centerline of each proposed position with masking
or painting tape.
For unitary mounts, position as close as possible to
directly above the row unit to be served. For split
mounts, position as close as possible to halfway
between the row units to be served.
Repeat Step 49 through Step 54 until all frames are
mounted:
Refer to Figure 23
49. Select:
one
➀
Smartbox frame,
two (18) 403-319D,
(SMART BOX HOLD DOWN CLAMP),
two (27) 802-223C,
(HHCS 3/8-16X4 GR5),
two (26) 802-079C,
(HHCS 3/8-16X1 1/4 GR5), and
four (31) 803-209C,
(NUT FLANGE LOCK 3/8-16 PLT)
50. Insert a 1
1 ⁄
4
in bolt (26) in the slotted mounting hole
just forward of center
➁
on one side of the frame
➀
. Slip the shorter end of a clamp (18) over the
bolt (26) and add a flange lock nut (31). Put only a
few turns on the nut.
51. Position the frame
➀
.
52. Insert a 4in bolt (27) in the forward slotted hole
➄
of the frame
➀
, and then down through the hole in
the clamp (18), and add a flange lock nut (31). Put
only a few turns on the nut.
53. Repeat Step 33 through Step 35 for the other side
of the frame
➀
.
54. Position Smartbox base container/meter or
container/splitter/meter assembly
➅
in the frame
➀
, having the meter ports biased per the table on
page 8, and secure with fasteners provided by
AMVAC.
Figure 23
Outboard Wing Mount
25328
➁
18
27
31
26
U
D
B
F
R
L
➀
18
➄
➂