SARGENT R8200 with Simpli Roseless Trim - Manual (Page 4)

How To Change Hand of Lock
SARGENT R8200 Series Mortise Lock Function List
Note: Beveled surface of latch must face strike. The
deadlatch is self adjusting. To change hand of latch:
Note: Red surface of locking piece must face secure
(keyed/locked) side of door.
To rotate locking piece:
1. Position lockbody with red surface of locking piece visible
2. Insert blade type screwdriver into locking piece slot to rotate
locking piece
3. Push locking piece toward back of lock body and rotate 180°
until RED surface shows on opposite side
IMPORTANT: 04, 06, 13, 17 and 31 Functions require:
a. Green catch screw to be removed
b. Rotate hub 45 degrees
to vertical position
c. Rotate locking piece
for required hand
d. Red surface faces
locked side of door
e. Rotate hub to the
original 45 degree
position as shown
on lockcase
f. Green catch screw
is then reinstalled
Red color indicates
locked side of door Locking
piece
slot
1. Insert flat blade screwdriver
into the spade shaped slot
2. Rotate screwdriver 90º to push latch out until back
of latch clears lock front. Then rotate latch 180º.
Latch will then re-enter lockbody.
(Note: Latch can not be unscrewed)
NOTE: 05 FUNCTION HAS A THUMB TURN ON THE INSIDE FACE
OF DOOR AND 55 FUNCTION HAS TOGGLE ON LOCK FRONT
Note: Shaded Levers are Rigid at all times
4
A8030:A 4/16/10
Copyright © 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.