SARGENT 351 Series Aluminum Closer - Manual

LEFT
HAND DOOR
RIGHT
HAND DOOR
PULL
HINGE SIDE
PULL
HINGE SIDE
STOP (PUSH) SIDE STOP (PUSH) SIDE
NUMBER OF TURNS OF SPRING POWER ADJUSTING SCREW
FROM FACTORY SETTING (USE CHART AS GUIDE ONLY)
DOOR WIDTH
(INCHES)
24
30
32
36
40
42
44
46
48
OVER 48
EXTERIOR DOORS
FACTORY SET
1-4 CW
4-7 CW
7-10 CW
10-12 CW
UP TO 18 CW AS REQ.
INTERIOR DOORS
1-5 CCW
FACTORY SET
1-5 CW
5 CW AND UP AS REQ.
APPROXIMATE
DOOR WEIGHT (POUNDS)
80
110
115
130
150
155
165
170
180
NUMBER OF TURNS OF SPRING POWER ADJUSTING NUT
FROM FACTORY SETTING (USE CHART AS GUIDE ONLY)
DOOR WIDTH
(INCHES)
24
30
32
36
40
42
44
46
48
OVER 48
EXTERIOR DOORS
2-6 CW
6-8 CW
8-11 CW
11-13 CW
UP TO 18 CW AS REQ.
INTERIOR DOORS
1-5 CCW
FACTORY SET
1-7 CW
8 CW AND UP AS REQ.
APPROXIMATE
DOOR WEIGHT (POUNDS)
80
110
115
130
150
155
165
170
180
ADJUST SPRING POWER ACCORDING TO CHART*
*ADJUST SPRING POWER ACCORDING TO CHART*
INCREASE
POWER
CLOCKWISE
(CW)
DECREASE
POWER
COUNTER CLOCKWISE
(CCW)
+
-
*IF INTERIOR DOORS DO NOT HAVE TO COMPLY WITH ADA REQUIREMENTS, EXTERIOR DOOR SETTINGS ARE RECOMMENDED.
WHERE STRONG DRAFTS EXIST, INCREASE SPRING POWER AS NEEDED BY TURNING SPRING ADJUSTMENT SCREW CLOCKWISE.
IF NECESSARY, REDUCE SPRING POWER BY TURNING SCREW COUNTERCLOCKWISE.
5/8" SPRING POWER
ADJUSTMENT NUT
STANDARD APPLICATION
(TYPE 25-F ARM)
TOP JAMB APPLICATION
(TYPE 25-F, 25-FZ AND 25-FZA ARMS)
PARALLEL ARM
APPLICATION
(TYPE 25-PF9 ARM)
CLOSER MOUNTED ON
STOP SIDE OF DOOR
CLOSER MOUNTED ON FRAME
ON STOP SIDE OF DOOR
NOTE: FOR F8 ARM MOUNTING
SEE DATA SHEET ENCLOSED
USE
PAGE 2
USE
PAGE 3
USE
PAGE 4
CLOSER MOUNTED ON
HINGE SIDE OF DOOR
1
INSTALLATION INSTRUCTIONS MODEL 351 POWERGLIDE
DOOR CLOSERS HOLD OPEN ARMS WITH FUSIBLE LINK
351 NON SIZED ADJUSTABLE SIZES 1 THROUGH 6
COMPLIES WITH ADA REQUIREMENTS
FOR INSTALLATION ASSISTANCE CALL SARGENT AT 1-800-727-5477 • www.sargentlock.com
Copyright © 2009, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7342A
STANDARD & TOP JAMB APPLICATIONS
PARALLEL APPLICATION ONLY