Canon SX6 - Manual (Page 25)

25
BE
FORE USE
Input Terminals on Main Unit
(1) Input Terminal-1 (DIGITAL IN/ANALOG IN-1) (P32, 33, 57)
Receives a digital (DIGITAL PC) and analog PC signal (ANALOG PC-1).
Receives a digital content image signal (DIGITAL VIDEO).
(2) Input Terminal-2 (ANALOG IN-2) (P32, 33, 56)
Receives an analog PC signal (ANALOG PC-2).
Receives a component and SCART image signal (COMPONENT/SCART).
(3) Monitor Output Terminal ( ) (P34)
Outputs an analog PC signal to display an image on an external monitor.
(4) SERVICE PORT jack
Exclusively used by the service personnel (it is not used normally).
(5) S-VIDEO IN terminal (P57)
Receives an S-Video signal from an AV equipment.
(6) VIDEO IN terminal (P58)
Receives a composite video signal from an AV equipment.
(7) AUDIO IN terminal (P34)
Receives an audio signal from a computer or AV equipment.
(8) USB terminal (P70)
Connected to the computer with a USB cable when the remote control is used
as the mouse of the computer. (you cannot use this terminal to receive any
video image)
(9) Input Terminal Indicator (P43, 61)
Indicates the input signal status.
Green
: The input signal is confirmed and an image is projected.
Flashing green : The input signal is confirmed but no image is projected.
Off
: An input signal is not confirmed (a cable is not connected).
(1) (2) (3)
(7)
(6)
(5)
(4)
(8)
(9):