Tweco VA 4000 Ultra-Feed - Manual (Page 25)

ULTRAFEED VA 4000
September 18, 2012 3-3
3.06 Input And Output Wire Guide Installation
Refer to Figure 3-2.
Install the input wire guide (the longer one) by loosening the input guide lockscrew and inserting the guide into the
hole in the feedhead assembly. The recessed end of the guide should be toward the wire spool. Adjust the guide so that
it is clear of the feed rolls and tighten the input guide lockscrew.
Install the output wire guide in the same manner, with the conical end toward the feed rolls. The tip of the conical end
should be as close to the feed rolls as practical. Tighten the output guide lockscrew.
NOTE
Before tightening the input and output guide lockscrews, install the drive roll to help in the alignment of the
wire guides.
Art # A-07376
Output Wire Guide
Input Guide Lockscrew
Input Wire Guide
Output Wire Lockscrew
Center Wire Guide
Figure 3-2: Wire Guide Installation