Tweco Ultima 150 - Manual (Page 16)

SECTION 2: GENERAL INFORMATION 10 Manual 0-2472
2.04 The ULTIMA-150 System
The ULTIMA-150 Plasma Welding System includes the
following components:
• ULTIMA-150 Power Supply with 10 ft Gas Supply
Hoses (2)
• Quick Disconnect Torch with leads (torch type and
lead length as ordered)
• Torch Spare Parts Kit
• Thermal Arc Coolant - 2 gallons
• 10 ft Work Cable with Cable Lug connector.
Figure 2-1 The ULTIMA-150 System
2.05 Requirements to Complete
System
To complete the system, the user needs the following:
• Remote signal to operate Arc ON/OFF via TB-1 in-
terface or J-20 receptacle using accessory remote de-
vice
• Gas Pressure Regulators. Both Argon Gas Regula-
tor and Argon/Hydrogen Gas Regulators are avail-
able through Thermal Dynamics
• Power Input Cable
2.06 Options, Accessories, and
Replacement Parts
Options and accessories are available for the ULTIMA-
150 Plasma Welding Power Supply to customize it for a
particular application or to further enhance performance.
For more information, refer to Section 6, Parts Replace-
ment.
• Quick Disconnect Adapter Kit - For use with older
model Thermal Arc torches. The Adapter Kit retro-
fits the torch for direct connection to the quick dis-
connect receptacle on the Power Supply.
• Torch Spare Parts Kit - Kit contains replacement front
end torch parts.
• 575-Volt Transformer Module - A step-down trans-
former which converts 575V primary power to 460V
for use with the ULTIMA-150 Plasma Welding Power
Supply.
• Remote Current Control Device - Required for opera-
tion of the ULTIMA-150 Plasma Welding System.
• Weld Sequencer - An add-on accessory for control-
ling weld timing, pulsing, current slope, and gas
slope.
• Coolant Pressure Gauge Assembly Kit - This kit al-
lows for easy monitoring and adjusting of coolant
pressure.