Tweco 200 XT Ultra-Cut Plasma Cutting System With Automated Gas Control - Manual (Page 74)

ULTRA-CUT 200 XT
4-4 OPERATION Manual 0-5304
4.04 TSC-3000 Initial Setup ONLY
Initial steps required before First operation only. Note 400 Amp system requires a Height
Controller with Elevation Height (EH) feature.
1a
5
4
2
1
Select language and
measurement units.
Enter SYSTEM UTILITY
(3).
3
When power is turned on
TSC 3000 goes to the Home
screen. For new installation
it is required to perform
initial SETUP.
Press SETUP button (1).
Enter Initial default
PASSWORD 00000 (2)
HOME
Enter XT lead (DPC
to Torch); only 4’ currently
allowed.
Enter DFC 3000 lead
length (DMC to DPC);
Utility Screen 2 is for
information only.
Displays Device and
Cutchart IDs, setting of
options switches etc.
Utility screen 3 (5)
allows viewing
consumable statistics,
Starts, Hours, Errors.
Return to Home Screen.
ENTER/CHANGE PASSWORD
SETUP
To change Password press
SET PASSWORD enter
new 5 digit password (1a).
Press green arrow to accept
new password and return to
SETUP screen (2).
Set Elevation Height Support
to “Yes” if height control
supports that feature.
Elevation Height Feature
is required for the
Ultra-Cut 400
UTILITY 1 of 3
UTILITY 2 of 3
UTILITY 3 of 3
Art # A-09656