Tweco 300 XT Auto-Cut 380V - Manual (Page 43)

AUTO-CUT 300 XT
Manual 0-5261 INSTALLATION 3-19
Assembled Cartridge
Cartridge Tool
Shield Cup
Art # A-04344_AB
Installing Shield Cup Onto Cartridge
6. Take the removal tool off the cartridge. Fit the cartridge assembly onto the torch head. The cartridge should
seal to the large O-ring on the torch body as shown. If the cartridge does not seal on the O-ring, the cartridge
is not fully tightened.
CAUTION
Do not force the cartridge if it will not fully tighten. Remove the cartridge and gently clean the threads on the torch
head body with a wire brush. Apply oxygen-compatible lubricant (supplied with the torch) to the threads.
Art # A-03893
Torch Head
Assembled Cartridge
Installing Assembled Cartridge Onto Torch Head