Tweco 200 Auto-Cut User Manual

Page 3

WARNINGS

Read and understand this entire Manual and your employer's safety practices before
installing, operating, or servicing the equipment.

While the information contained in this Manual represents the Manufacturer's best judge-
ment, the Manufacturer assumes no liability for its use.

Plasma Cutting Power Supply, Auto-Cut

200

Operating Manual No. 0-4805

Published by:
Victor Technologies
16052 Swingley Ridge Road, Suite 300
Chersterfield, MO 63017
636-728-3000

www.thermal-dynamics.com

Reproduction of this work, in whole or in part, without written per-
mission of the publisher is prohibited.

The publisher does not assume and hereby disclaims any liability to
any party for any loss or damage caused by any error or omission
in this Manual, whether such error results from negligence, acci-
dent, or any other cause.

Publication Date: October 7, 2005
Revision Date: January 8, 2013

Record the following information for Warranty purposes:

Where Purchased: ___________________________________

Purchase Date:______________________________________

Power Supply Serial #:_______________________________

Torch Serial #:_______________________________________