Tweco 100 Ultra-Cut User Manual

Page 3

WARNINGS

Read and understand this entire Manual and your employer’s safety practices before installing, operating,
or servicing the equipment.

While the information contained in this Manual represents the Manufacturer's best judgement,
the Manufacturer assumes no liability for its use.

Plasma Cutting Power Supply, Ultra-Cut

100

Operting Manual No. 0-4748
Published by:
Thermadyne Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711

www.thermal-dynamics.com

Reproduction of this work, in whole or in part, without written permission
of the publisher is prohibited.

The publisher does not assume and hereby disclaims any liability to any
party for any loss or damage caused by any error or omission in this
Manual, whether such error results from negligence, accident, or any
other cause.

Printed in the United States of America

Licensed under U. S. Patent No. 5,070,227

Publication Date: July 1, 2005
Revision Date: September 8, 2011

Record the following information for Warranty purposes:

Where Purchased: ___________________________________

Purchase Date:______________________________________

Power Supply Serial #:_______________________________

Torch Serial #:_____________________________________