Kessler MOTION CONTROL: Oracle Controller Full (2.06.2 SL) - Manual (Page 31)

12. Once your start point has been set, press the the MIDDLE
JOYSTICK BUTTON or ENTER to begin the calibration
13. The screen will display Slider On with a countdown.
14. Let the calibration complete. If you need to cut the calibration
short you can hit the MENU Button at any time.
NOTE:
The shorter the calibration time, the less accurate the calibration.
15. To complete the calibration, measure the distance between
your start point (A) and ending point (B).
16. Move the joystick LEFT/RIGHT to adjust the values in the
ORACLE to match the distance in inches or centimeters that
the carriage moved during the calibration.
This number will vary in distance depending on your specific
setup / motor selection.
Press ENTER or the MIDDLE JOYSTICK BUTTON to confirm
Set Start Point
ENTER: Begin
Slider On 1505
SLIDER/DOLLY TIME LAPSE CALIBRATION
MOTION CONTROL - SIMPLE
CONTINUED
17. Press ENTER or the MIDDLE JOYSTICK BUTTON again to save
calibration data, or MENU to cancel calibration data.
18. Your system is now calibrated for accurate moves as the
ORACLE now knows how far over time the carriage will move
with setup used in calibration.
Quick Tip:
If moving between extreme environmental conditions, major camera
weight changes, or different incline angles, we recommend running the
calibration again to insure accuracy.
Adj Dist Moved
2.75IN 6.98CM
31