E-flite Edge 540 BP 3D ARF - Manual (Page 21)

1 E-flite Edge 540 BP ARF Assembly Manual
  6. Enlarge the outer hole in the servo arm using a 1 /
16
-
inch (1.5mm) drill bit. Attach a pushrod control connector
to a long 3D servo horn. Remove the remaining arm using
a hobby knife or side cutters.
  7. Turn the radio system on and center all the trims and
sticks. Also make sure you are starting with a clean
program if using a programmable radio. Check the
operation of the servos at this time.
  8. With the radio system on, attach the servo horn to
the aileron servo. Position the servo arm parallel to the
aileron hinge line.