E-flite Edge 540 BP 3D ARF - Manual (Page 20)

0 E-flite Edge 540 BP ARF Assembly Manual
 4. Secure the receiver to the fuselage under the wing using
hook and loop tape. Route the antenna wires according to
the manual provided with your radio system. Plug the servos
into the appropriate positions in the receiver.
Note: Make sure all the wires are neatly taped to the
fuselage to prevent them from getting entangled with
the linkages.
Hint: With all the servo leads on the same side of the
fuselage the radio installation will look neat and tidy.
  5. Apply thick CA to the bottom plate of the control horn
and slide the control horn into the holes from the bottom
of the aileron. Apply a few drops of thin CA to the posts
from the top of the aileron. Apply thick CA to the bottom
of the control horn backplate and slide the control horn
backplate into position, making sure the horn is solidly
secured. Apply a couple drops of thin CA where the posts
protrude through the backplate.