E-flite Edge 540 BP 3D ARF - Manual (Page 11)

11 E-flite Edge 540 BP ARF Assembly Manual
Hinging
Required Parts
Airframe
CA hinges (17)
Elevator (left and right)
Aileron (left and right)
Rudder
Plywood elevator joiner
Required Tools and Adhesives
Thin CA
T-pins
Straight edge
 1. Remove the covering from one elevator to expose the slot
for the plywood elevator joiner. Slide the joiner into position
and check it is aligned with the front edge of the elevator
using a straight edge. Wick thin CA into the joint between
the joiner and elevator to secure the joiner in position.
  2. Trim three hinges from the hinge sheet. Place a T-pin in
the center of each hinge.
  3. Slide the hinges into the pre-cut slots of the elevator.