E-flite Edge 540 BP 3D ARF - Manual (Page 18)

18 E-flite Edge 540 BP ARF Assembly Manual
Radio Installation
Required Parts
Assembled airframe
Carbon linkage w/nylon clevis (rudder), 13-inch (330mm)
Carbon linkage w/nylon clevis (elevator) 11-inch (282mm)
Carbon linkage w/nylon clevis (aileron) (2) 5
3 /
8
-inch (133mm)
Control horn w/backplate (4)
Pushrod screw lock connector w/hardware (4)
Servos w/hardware (4)
3D length servo arms (4)
Radio system w/receiver
Required Tools and Adhesives
Phillips screwdriver (small)
Felt-tipped pen
Thick CA
Drill
Drill bit:
1 /
16
-inch (1.5mm)
Hook and loop tape
Hobby knife (#11 blade)
 1. Remove the arms from your four servos. Install two
servos into the openings on the bottom of the wing using the
hardware provided with the servos. Make sure to position the
output of the servo toward the rear of the plane, and to have
the servo leads accessible from the bottom of the airplane.
Pre-drill the holes for the servo mounting screws using a drill
and
1 /
16
-inch (1.5mm) drill bit.
Hint: Pass both servo leads to the same side of the
fuselage for a cleaner radio installation.