E-flite Pulse XT 25e ARF User Manual

Page 3

Using This Manual

This manual is divided into sections to make assembly of the model easier to

understand and to provide breaks between each major section.

In addition, check boxes have been placed next to each step to keep track of

each step completed. Steps with a single circle (Ο) are performed once, while

steps with two circles (Ο Ο) indicate that the step will require repeating, such

as for a right or left wing panel, two servos, etc.

We recommend reading through the entire manual before beginning assembly

in order to familiarize yourself with the model and its assembly.

Preparation

Your Pulse XT 25e arrives prefinished and it is recommended that you take

time to properly prepare your work area. Clean off your work surface and lay

down a foam pad or blanket to protect the finish of your model.

This is also a good time to check through the list of required parts and tools

and obtain any items not on hand that you may need to complete the model.

Inspection

Before beginning assembly of your Pulse XT 25e, inspect the kit contents and

take an inventory of the parts. If any parts are missing, defective or damaged,

contact Horizon Hobby, Inc. for assistance.

Direct your email to: [email protected] or call

877-504-0233 toll-free to speak to a service technician.

Kit Contents

1. Left wing panel

7. Cowling

2. Right wing panel

8. Spinner

3. Fuselage

9. Forward and aft (float) landing gear

4. Horizontal stabilizer

10. Wheel pants

5. Vertical stabilizer

11. Pushrod set

6. Canopy

Not pictured:

- Accessory bag (cooling scoop, control hardware, hook and loop material)

- Wing parts bag (dihedral joiners, wing dowels and aileron pushrods)

- Hardware bag (bolts, screws, washers, spacers)

- Float mount spacers (4)

Product Registration