E-flite Pulse XT 25e ARF User Manual

Page 17

Wing Joining

Required Parts

Wing halves (L and R)

(2) dihedral joiners

(2) leading edge dowels

(2) 6-32 x 1” socket head bolts

(2) #6 steel washers

Required Tools and Adhesives

Low-tack tape

12-minute epoxy

Clear tape

7/64” balldriver

Mixing cups

Mixing sticks

Rubbing alcohol

Paper towels

Ο Ο 1. Install the leading edge dowels in the wing panels with 12-minute

epoxy. Use paper towels and rubbing alcohol to clean any epoxy that

squeezes out onto the wing.

Ο Ο 2.. Upon installation, approximately 5/16” to 3/8” of the dowel should

protrude from the leading edge of the wing.

Ο Ο 3. The rear side of the dowel is accessible through the wing root rib and a

small amount of epoxy can be added here to secure its installation.