E-flite Pulse XT 25e ARF - Manual (Page 18)

18
Ο 4. Apply low-tack tape to the upper and lower surfaces of the center of the
wing panels as shown. This will allow for easy clean up of any excess glue and
make for a clean joint.
Ο 5. Apply a piece of clear tape to the front and rear wing saddle area where
the wing leading and trailing edges will come in contact with the fuselage.
Ο 6. 12-minute epoxy is used to install the dihedral joiners and join the wing.
Glue the two dihedral joiners to each other.
Ο 7. Using a mixing stick, apply epoxy to the dihedral joiner slot in each wing
panel, and to the exposed root rib of one wing panel.