E-flite Pulse XT 25e ARF - Manual (Page 25)

Ο 7. Install the rudder assembly, steering arm and pushrod connector on the
nylon bracket. Refer to pages 12 and 13 in the Float Set assembly manual for
guidance. The pushrod connector will go in the hole closest to the rudder post.
Ο 8. Install a pushrod connector on the outermost hole in the rudder horn as
shown. Refer to page 13 of the Float Set assembly manual for guidance.
Ο 9. The Sullivan flex cable and tube need to be cut to length prior to
installation. The cable length will be approximately 31.5 in and the tube length
approximately 26.5 in.
With the pushrod cable inside the pushrod tube, attach the tube to the float
with a full brass strap and two 2mm x 10mm sheet metal screws.The end of
the pushrod tube will be approximately 1.5” behind the brass strap. The cable
can now be installed in the pushrod connector with a 3mm setscrew as shown.
Ο 10. Install the other end of the cable in the pushrod connector on the rudder
horn as shown and secure with a 3mm setscrew using a 1.5mm Allen wrench.
25