E-flite Pulse XT 25e ARF - Manual (Page 13)

Motor and Battery Installation
E-flite Power 32
Required Parts
E-flite Power 32 Motor with hardware
E-flite 60A ESC
E-flite Battery
Propeller
(4) 4-40 x 3/4" socket head bolts
Adhesive backed hook and loop tape
(2) Hook and loop straps
(4) 4mm aluminum motor mount spacers
Required Tools
3/32” balldriver
#1 Philips screwdriver
Threadlock
Ο 1. Using a #1 Philips screwdriver, install the mount on the rear of the motor
using the countersunk Philips head screws included with the motor. You may
use threadlock to prevent these screws vibrating loose during flight.
Ο 2.. Using a 3/32” balldriver, install the motor on the firewall with four 4-40
x 3/4" socket head bolts and four 4mm aluminum spacers. The motor wires
should exit towards the bottom of the fuselage. You may use threadlock to
prevent these screws from vibrating loose in flight.
Ο 3. Remove the battery hatch by sliding it forward to disengage the magnets,
and lifting at the rear. It can then be pulled rearwards and off the model.
13