E-flite Pulse XT 25e ARF - Manual (Page 20)

20
Ο 2. A string is provided in each wing half to draw the aileron lead through
the wing. Attach the end of the string to the aileron servo lead and pull it
carefully through the wing to the center. Once both leads have been pulled
through, they can be secured to each other with tape to prevent them falling
back into the wing.
Ο Ο 3. Place the servos in the wing openings and mark the screw hole
locations with a felt-tip pen.
Ο Ο 4. Using a 1/16 in (1.5mm) drill bit in a pin drill, drill the four mounting
holes for each aileron servo. After drilling, apply a small drop of thin CA to
each hole to strengthen the wood.
Ο Ο 5. Using a #0 Philips screwdriver, and the screws provided with the
servos, install the aileron servos with the output shaft towards the trailing edge
of the wing.