E-flite Pulse XT 25e ARF - Manual (Page 21)

Ο Ο 7. Prepare each of the 4-3/4” long aileron pushrods with a clevis and
silicone keeper.
Ο Ο 8. Center the aileron servo using your radio or JR MatchMaker. Attach
the clevis to the aileron horn at the third hole from the surface and mark the
length at the servo arm. Bend the pushrod up (away from the wing surface) at
this location and install it on the servo arm with a pushrod keeper.
Ο Ο 6. Using a #1 Philips screwdriver remove the servo horn. Using sidecutters
remove three of the four arms, leaving one long arm. Using a pin drill, enlarge
the outermost hole to 5/64 in (2mm) to accept the pushrod. Center the servo
and install the arm towards the wing tip as shown.
9. Follow steps 3 through 8 to install the opposite aileron servo.
21