E-flite Fokker DVII 250 ARF - Manual (Page 6)

6 E-flite Fokker DVII 250 Slow Flyer Assembly Manual
 4. Slide the propeller adapter on the motor and use
a .050-inch hex wrench to tighten the setscrew that
secures the adapter to the motor shaft. Make sure
to position the edge where the propeller will rest at
a minimum of 1 3 /
8
inches (35mm) forward of the
firewall as shown.
Speed Control Installation
Required Parts
Fuselage assembly
Speed control
Tie wrap (not included)
Two-sided tape
 1. Mount the speed control using two-sided tape to
the front of the fuselage as shown below.
 2. Connect the wires from the motor to the
appropriate wires of the speed control. Route the
wires so they will not interfere with the operation of
the motor.
Hooking up the colored wires in respect to
their colors will result in the correct motor
direction if using all E-flite components.