E-flite Fokker DVII 250 ARF - Manual (Page 16)

16 E-flite Fokker DVII 250 Slow Flyer Assembly Manual
 3. Use foam-safe CA to glue the outer strut to the
top and bottom wing after checking the fit of the
strut. Allow the CA to fully cure before proceeding.
 4. Repeat Steps 2 and 3 to install the remaining
outer strut.
Landing Gear Installation
Required Parts
Fuselage assembly
Landing gear
Wheel (2)
Wheel retainer (2) Double-sided tape
Required Tools and Adhesives
Hobby knife with #11 blade Foam-safe CA
Low-temp hot glue
 1. Slide one of the wheels onto the landing gear.
The wheel should rotate freely on the gear. If not,
use a hobby knife and #11 blade to enlarge the
hole in the wheel slightly for free rotation.
 2. Slide the wheel retainer onto the landing gear
wire. Use a drop of foam-safe CA on the side
away from the wheel to secure the retainer. Make
sure not to get CA on the wheel or axle, preventing
the wheel from rotating.
 3. Install the remaining wheel and secure it
following the procedure described in Steps 1
and 2.