E-flite Fokker DVII 250 ARF - Manual (Page 15)

15 E-flite Fokker DVII 250 Slow Flyer Assembly Manual
 3. Set the top wing in place and align the trailing
edges looking down from above. You will notice
a slight amount of adjustment is required on the
cabane struts.
 3. Once the procedure for installing the cabane
strut has been practiced, mix a small amount of
30-minute epoxy and apply it to the ends of the
strut. Insert the strut in the fuselage as described
previously. Install both struts at this time.
Top Wing and Outer Strut Installation
Required Parts
Airframe Top wing
Outer strut (2)
Required Tools and Adhesives
Foam-safe CA
 1. Use foam-safe CA to glue the top wing to the
cabane strut.
 2. Locate the outer strut. Note the orientation as
shown in the photo below.