E-flite Fokker DVII 250 ARF - Manual (Page 20)

20 E-flite Fokker DVII 250 Slow Flyer Assembly Manual
 11. The rigging now heads to the rear hole in the
outer strut. Again, this line will be in front of the
current rigging lines.
 12. Route the rigging up and to the forward hole in
the outer strut.
 13. The rigging now goes down and through the
forward tube in the fuselage. This line will be in
front of all the other rigging lines.
 14. After exiting the fuselage, route the rigging up
to the forward hole in the outer strut. Make sure
the rigging is in front of all the previously installed
rigging lines.
 15. This completes the second stage of rigging. Use
low-tack tape to secure the tape on the underside
of the bottom wing. The end taped will be secured
once the rigging is ready to be tensioned.