E-flite Fokker DVII 250 ARF - Manual (Page 17)

17 E-flite Fokker DVII 250 Slow Flyer Assembly Manual
 4. Make sure the receiver is out of the way of the
landing gear area as well as the connector for the
battery on the speed control.
 5. Slide the landing gear in the fuselage. The
rear of the gear fits into the slot in the middle of
the bottom wing, while the front of the gear fits
between the formers of the fuselage right behind
the cowling. Press the gear in until fully seated,
making sure not to damage the fuselage in the
process.
 6. You may find the gear is slightly loose when
installed. Use foam-safe CA to glue the landing
gear wire in position so it does not separate from
the airframe in flight.
 7. Use double-sided tape to secure the receiver in
the fuselage as shown. Make sure both antenna
wires are straight out of the receiver for the best
reception of the radio system.
 8. Use low-temp hot glue to attach the landing gear
wing to the landing gear. Use three small dots of
glue to glue the wing in place.