E-flite Fokker DVII 250 ARF - Manual (Page 14)

14 E-flite Fokker DVII 250 Slow Flyer Assembly Manual
Scale Accessory Installation
Required Parts
Airframe Machine gun (right and left)
Required Tools and Adhesives
Foam-safe CA
 1. Use foam-safe CA to attach the machine gun to
the top of the fuselage.
There is a right and left machine gun. Make sure
the clip from each machine gun faces away from
the fuselage center line as shown in the photos.
Bottom Wing
Required Parts
Fuselage assembly Bottom wing
2mm x 8mm wood screw (4)
Required Tools and Adhesives
Phillips screwdriver: #1
 1. Use a #1 Phillips screwdriver and four 2mm x
8mm wood screws to secure the bottom wing to the
fuselage. Ensure you do not overtighten the screws
and crush the wing.
Cabane Strut Installation
Required Parts
Fuselage assembly Cabane strut (right and left)
Top wing
Required Tools and Adhesives
30-minute epoxy
 1. Locate the cabane struts. Note that they are pre-
bent to fit to the fuselage.
 2. You will want to test fit the strut to the fuselage as
they can be tricky to install. Insert each end of the
strut in the order shown when fitting the cabane strut.