E-flite Mini Edge 3D ARF - Manual (Page 5)

5
Extreme High Performance
Motor Setup*
EFLM1100 Park 400 Brushless Motor, 4200Kv
EFLM1912 Heat Sink, 20mm x 20mm: Park 400
EFLP1260 12 x 6 Slow Flyer Prop
(keep extras on hand)
EFLB1035 11.1V 2100mAh 3-Cell Li-Po, 16GA or
THP21003S 2100mAh 3-Cell 11.1V Li-Po, 16GA
* Use with included 12 x 6 prop, 6.6:1 gearbox, and 10T
pinion. Proper throttle management is required when using
high performance setups. Always monitor motor temperature
and gearbox wear.
Optional Accessories
EFLA110 Power Meter
EFLA212 Gear Puller: 1–5mm Shaft
JRPS281 DS281 Micro Digital Servo (4)
Additional Tools and Adhesives
Tools & Equipment
Hobby knife Square
Ruler Felt-tipped pen
T-pins Paper towel / tissue
Heat gun
Wax paper
String
Tape Pliers
Drill Drill bit: 1/16" (2mm), 1/8" (3mm)
150–180 Grit sandpaper
Hex wrench: 3/32" (EFLA251 - included with EFLA250)
Nut driver: 5.5mm (EFLA255 - included with EFLA250)
Small Phillips screwdriver (EFLA257 - included with
EFLA250)
Adhesives
Thin CA Medium CA
Canopy glue Threadlock
6-Minute Epoxy - (HAN8000)