E-flite Mini Edge 3D ARF - Manual (Page 22)

22
 7. Slide the stab and elevator back into position. Again,
check the alignment and make sure everything lines
up. Wick Thin CA into the joint between the fuselage
and stabilizer. Make sure to glue both top and bottom.
Do not use accelerator—allow the CA to wick in as far
as possible, providing the best bond. Place the filler
plug in place behind the elevator, but do not glue at
this time.
Rudder and Fin
Required Parts
Fuselage Rudder
Fin CA hinge (3)
Required Tools and Adhesives
Hobby knife Thin CA
Felt-tipped pen Square
 1. Place the fin in position on the fuselage. Trace the
outline of the fuselage onto both sides of the fin.