E-flite Mini Edge 3D ARF - Manual (Page 30)

30
Note : An optional rudder servo location has
been provided at the rear of the fuselage if
using heavier motors and you choose not to use
the pull-pull system. The installation procedure
is identical to the elevator servo installation,
except the covering must be removed from the
fuselage first.
Note : Steps 6 through 13 illustrate the
installation of the pull-pull system. When
using the pull-pull system continue on starting
at Step 6.
 5. Lightly sand both sides of the middle section of the
plastic rudder control horn before installing so the
CA wicks better. Install the rudder control horn for
the rudder using medium CA. Square the horn to the
control surface.
 6. Install the grommets and brass eyelets in the rudder
servo. Mount the rudder servo using the hardware
provided with the servo.