E-flite Mini Edge 3D ARF - Manual (Page 39)

39
 2. Attach the propeller and spinner using the supplied
3mm washer and 3mm locknut. Make sure not to over-
tighten the 3mm locknut.
Note : It is very important that you check to be
sure the propeller is balanced before installing
onto the shaft. An unbalanced propeller may
strip the gear. When installing the propeller,
please do not over-tighten the 3mm locknut.
The use of the locknut will prevent the propeller
from coming loose.
 3. Check to make sure the propeller and spinner will
not interfere with the front of the cowl and there is
adequate clearance. Use a hobby knife to make holes
in the cowl at the same location as the tabs on the
fuselage. Secure the cowl to the fuselage using the
2mm x 8mm wood screws and a Phillips screwdriver.