E-flite Mini Edge 3D ARF - Manual (Page 31)

31
 7. Install two micro control connectors into a long
servo arm. Secure them using the control connector
back plates.
 8. With the radio system on, install the servo arm on
the rudder servo.
 9. Use tape to hold the rudder in neutral. Slide a cable
crimp onto the control cable. The cable then goes
through the horn, then back through the crimp
twice. Pull the wire tight, then use pliers to secure
the crimp. Add a small drop of thin CA inside the
brass crimp to help secure the wire. Wipe away
any excess immediately.