Brother P2500 - Manual (Page 106)

CHAPTER 4 TROUBLESHOOTING
4-19
How to print correctly
This section provides information on the following topics:
problem with Copy Go to page 4-20
problem with Scan Go to page 4-21
Problem Recommendation
The printer prints
unexpectedly or it prints
garbage.
•
Check that the printer cable is not too long. We
recommend you use a parallel cable of less than 2
metres (6.6 feet) in length.
•
Check that the printer cable is not damaged or
broken.
•
If you are using an interface switching device,
remove it and connect your computer directly to your
printer and try again.
•
Check that the appropriate printer driver is selected as
‘Set as Default’.
•
Check that the printer is not connected to the same
port that is also connected to a mass storage device or
scanner.
Remove all other devices and connect the port to the
printer only.
Turn off printer status reporting in the device options
tab in the printer driver.
The printer cannot print
full pages of a document.
A "
MEMORY FULL " error
message occurs.
•
Press the Job Cancel button to print the data
remaining in the printer.
•
Reduce the print resolution or reduce the complexity
of your document.
•
Expand the printer memory by adding a Memory
Expansion board.
Refer to ‘How to add extra
Memory’ in Chapter 2.