Manually configuring network settings – Belkin F5D6231-4 User Manual

Page 73

Text mode
Original mode

MANUALLY CONFIGURING NETWORK SETTINGS

Select “Built-in Ethernet” (2) next to “Show in the Network menu.

Select the “TCP/IP” tab (3). Next to “Configure” (4), you should see
“Manually” or “Using DHCP”. If you do not, check the PPPoE tab (5) to
make sure that “Connect using PPPoE” is NOT selected. If it is, you will
need to configure your Router for a PPPoE connection type using your
user name and password.

If “Manually” is selected, your Router will need to be set up for a static
IP connection type. Write the address information in the table below. You
will need to enter this information into the Router.

If not already selected, select “Using DHCP” next to “Configure” (4),
then click “Apply Now”.

Your network settings are now configured for use with the Router.

(2)

(3)

(4)

(5)

P74122_F5D6231-4_man.qxd 11/6/02 1:04 PM Page 71