Banner SureCross DX80 Wireless Networks - Manual (Page 4)

Sample and Report Rates
The sample interval, or rate, defines how often the SureCross device samples the input. For battery-powered applications, setting a slow-
er rate extends the battery life.
The report rate defines how often the Node communicates the I/O status to the Gateway. Change of state reporting sets the system to
report only when the value crosses the threshold setting. For FlexPower™ applications, setting the report rate to a slower rate extends
the battery life.
5-Pin Euro-Style Female Pinout
The connections are completed using the 5-pin M12 Euro-style connector. The following table defines the wires and the appropriate
connection points in the SureCross radio.
No. Wire Color Description
1
2
3
4
5
1 brown power +
2 white device select
3 blue dc common (GND)
4 black device output
5 gray serial comms
LED Behavior for the Nodes
After powering up and binding the Gateway and its Nodes, verify all devices are communicating properly. A Node will not sample its
inputs until it is communicating with its Gateway. When testing communication between the Gateway and Node, all radios and antennas
should be at least two meters apart or the communications may fail.
LED 1 LED 2 Node Status
(flashing green)
Radio Link Ok
(flashing red) (flashing red)
Device Error
(flashing red, 1 per 3 sec)
No Radio Link
Storage Mode and Sleep Mode
While in storage mode, the radio does not operate. All SureCross® radios powered from an integrated battery ship from the factory in
storage mode to conserve the battery. To wake the device, press and hold button 1 for five seconds. To put any FlexPower® or integra-
ted battery SureCross radio into storage mode, press and hold button 1 for five seconds. The radio is in storage mode when the LEDs
stop blinking, but in some models, the LCD remains on for an additional minute after the radio enters storage mode. After a device has
entered storage mode, you must wait one minute before waking it.
During normal operation, the SureCross radio devices enter sleep mode after 15 minutes of operation. The radio continues to function,
but the LCD goes blank. To wake the device, press any button.
Modbus Register Table
I/O Point Modbus Holding Register I/O Type
Gateway Any Node
1 1 1 + (Node# × 16) Serial device 1, primary input 1 0h00
2 2 2 + (Node# × 16) Serial device 1, primary input 2; OR Discrete IN 3 0h01
3 3 3 + (Node# × 16) Serial device 1, primary input 3; OR Discrete IN 1 0h02
4 4 4 + (Node# × 16) Serial device 1, secondary input 1; OR Serial device 2, primary input 1 0h03*
0h00
SureCross DX80 Serial Node with Integrated Battery
4 www.bannerengineering.com - tel: 763-544-3164 P/N 137322 Rev. F