Metrohm 914 pH / Conductometer - Manual (Page 66)

4.10 Outputting reports/measured values
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
56 ￭￭￭￭￭￭￭￭
pH Meter/Conductometer
4.10 Outputting reports/measured values
The pH Meter/Conductometer supports the output of various printouts
and data transfers for displaying the calibration and measured values.
4.10.1 Printing out
The printouts are divided into various groups:
￭ Printing out values directly after generation:
– Calibration data
Calibration data can be printed out if on is selected under:
Menu
▶ Parameters X ▶ Calibration param. ▶ Report
– Measured values
Direct printing of the measured values can be done with the
or buttons.
￭ Printing saved values in the following areas as reports:
– Calibration
– Sensors
– Configuration
– Parameters
– Measured values
Printing of report data can be done via the Report selection dialog
under:
Menu
▶ Report
4.10.2 PC/LIMS and CSV data transfer
NOTE
USB cable
Data transfer to a PC requires a connection via the supplied USB cable
(6.2151.110).
The optional USB Y cable (6.2151.140) cannot be used.