Metrohm 914 pH / Conductometer - Manual (Page 25)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
pH Meter/Conductometer
￭￭￭￭￭￭￭￭ 15
NOTE
Charging the battery with power supply
The battery will not be overcharged if the instrument is used for
extended periods with the power supply unit connected. The instru-
ment is equipped with a charging controller to protect the battery.
3.2.3 Operation via USB connector (PC)
Operation of the instrument with power supply via a USB connector
requires a minimum capacity of 500 mAh (see Chapter 3.2.1, page 13).
3.3 Connecting sensors
Sensors can be connected while the instrument is running.
NOTE
Parameter setting
Please note that if you change the sensor the sensor has to be selected
in the menu dialog Menu
▶ Parameters X ▶ Measuring parame-
ters ▶ Sensor name or a new sensor has to be entered in the sensor
list.
NOTE
iConnect for iTrodes
Sensors from the iTrodes line are only supported by the 854 iCon-
nect series 07 or higher.
The series is indicated by the number 17 in the following serial number
example:
1854001017216