Metrohm 858 Professional Sample Processor - Manual (Page 42)

3.13 Connecting a computer ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
34 ￭￭￭￭￭￭￭￭ 858 Professional Sample Processor
6.2151.000
USB 2
USB 1 Contr. MSB 2
Figure 33 Connecting the computer
The instrument is recognized. The driver installation is carried out dif-
ferently, depending on the version of the Windows operating system
used.
￭ Either the required driver is installed automatically, or an installa-
tion wizard is started.
3 Follow the instructions of the installation wizard.
If problems should occur during installation, contact your company's IT
supporter.
Note
The plug on the instrument end of the 6.2151.000 controller cable is
protected against accidental disconnection by means of a pull-out pro-
tection feature. If you wish to pull out the plug, you will first need to
pull back the outer plug sleeve marked with arrows.
Registering and configuring the instrument in the PC soft-
ware
The instrument must be registered in the configuration of your PC soft-
ware. Once that has been done, you can then configure it according to
your requirements. Proceed as follows:
1 Set up the instrument
￭ Start the PC software.
The instrument is automatically recognized. The configuration dia-
log for the instrument is displayed.
￭ Make configuration settings for the instrument and its connec-
tors.