Metrohm 850 Professional IC Anion MCS Gradient - Manual (Page 69)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 Installation
850 Professional IC –Anion – MCS – Gradient
￭￭￭￭￭￭￭￭ 59
1
3
2
Figure 34 Conductivity detector rear
1 Detector cable
With mounted plug. 2 Detector output capillary
Permanently installed.
3 Type plate
With serial number.
Note
In order to prevent unnecessary peak widening after separation, the
connection between the outlet of the separation column and the inlet
in the detector should be kept as short as possible.
Connecting the detector input capillary to the MCS
1 ￭ Fasten the detector input capillary (35-1) using a 2.2744.090 long
PEEK pressure screw (35-2) on the output of the MCS (35-3).