Metrohm 850 Professional IC Anion MCS Gradient - Manual (Page 65)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 Installation
850 Professional IC –Anion – MCS – Gradient
￭￭￭￭￭￭￭￭ 55
3 Aspirating capillary
For aspirating air low in CO
2
(as a result of
CO
2
adsorption cartridge (32- 4 )).
4 PEEK pressure screw, long 6.2744.090
5 Capillary connection 6 Pressure screw, short 6.2744.070
Mounted on the air aspirating capillary.
7 Luer coupling 6.2744.120
Mounted on the air aspirating capillary with
pressure screw 6.2744.070.
Connecting the MCS
1 Connecting the MSM
Connect the eluent output capillary (labeled with Detector) using a
6.2744.090 long PEEK pressure screw (31-4) to the MCS inlet (31-1).
2 Connecting the detector
Connect the detector input capillary (33-3) using a long PEEK pres-
sure screw 6.2744.090 (31-4) to the MCS output (31-2).
Caution
If the MCS is not used, the input and output should be sealed with
6.2744.220 stoppers.
2.18.3 Installing the adsorption cartridges
For effective CO
2
removal, the air sucked through the degassing cell
should be as low in CO
2
as possible. To achieve this, the air is aspirated
through a 6.2837.000 CO
2
adsorption cartridge (32-4).
Moisture can block the CO
2
adsorption cartridge. In order to prevent this,
a 6.2837.010 H
2
O adsorption cartridge (32-7) is connected upstream.