CommScope Redwood version 2.1 User Manual
Page 18
SSYSTEM INSTALLATION GUIDE
18
Redwood System Installation Guide v2.1
Redwood System Installation Guide
4.10.1 Installing the Redwood Adapter in the Enclosure Box
To install, the Adapter is first slid into the large hole in the Adapter enclosure. The clamp is secured with
the Adapter cap flush to the enclosure’s bottom. Then the Adapter Card is plugged in with the Engine
and fixture wires attached. Wiring from the Adapter Card is trailed through the small exit channel on the
enclosure’s side. Care must be taken that the Engine and fixture wires are not pinched in this process.
The top half of the box is closed and the two halves are secured together with two 6-32 screws (provided).
The Redwood Adapter Enclosure should be mounted at two points to prevent rotation. When mounting is
complete, the Adapter must be pointed to the ground. Note that the fixture wire must be able to reach the
Adapter card within the mounted enclosure.
4.10.2 Installing the Redwood Sensor in the Enclosure Box
When installing the Redwood Sensor in the Enclosure box, be sure to use the clamp that ships with the
enclosure box and not the sensor ring as this will not fit inside the enclosure. Follow the instructions in
the prior section.