CommScope Redwood version 2.1 - Manual (Page 12)

SSYSTEM INSTALLATION GUIDE
12 Redwood System Installation Guide v2.1
Redwood System Installation Guide
4 Install Components
Once the cabling has been laid out you are ready to begin the overall installation. Detailed installation
instructions are available for each of the Redwood components. A short summary is included below.
4.1 Installing Gateways, Sensors & Adaptors in Air-handling Spaces
The Redwood Gateways, Sensors and Adaptors have been tested by UL to UL2043 that ensures low
smoke-emitting characteristics and suitable fire resistance for equipment that may be installed in
environmental air handling spaces, as described in Article 300.22(c) of the NEC (2011).
When the product is installed in air-handling spaces, such as above some suspended ceilings, the cabling
employed should be suitable under NEC (2011) Article 800.154 and marked accordingly for use in
plenums and air-handling spaces with regard to smoke propagation, such as CMP. The products and
wiring means should be installed in accordance with all applicable local regulations and practices.
4.2 Install Redwood Engine(s)
Depending on the location and number of engines you are
installing, the Engine is a 2U rack mountable system and
can be installed in a standard server rack via supplied rack-
mounting brackets or to the wall with a Redwood Systems
Wall Mount Kit.
See detailed instructions in the corresponding Redwood
Engine Installation Guide.
Engine can be rack mounted or secured to a wall using the Wall Mount Kit