Clay Paky HandsOn - Manual (Page 41)

Handson Manual
Prism
Add a prism part if your fxture has a
wheel with prisms. Prisms are identifed
by their number of facets. The most
typical prism has three facets, select a
one-facet prism for open or no-prism.
Lamp
To strike the lamp via DMX you can use the Lamp control. You can defne an On and an Of range for the
lamp.
Some fxtures require the lamp on/of control to hold for a specifc amount of time. This can be set in
the “Time” section of the Lamp part. If the fxtures manual indicates the value has to be set “for at least
3 seconds” then you can just enter a time of 3; Handson automatically adds an extra second.
Reset
The fxture reset can be defned in the Reset part. This part only has an On property that you can set.
Most fxtures require the reset to be pressed for an amount of time. If the fxtures manual indicates the
value has to be set “for at least 3 seconds” then you can just enter a time of 3; Handson automatically
adds an extra second.
Fog
When you are creating a personality fle for a fog machine or hazer you can use the fog attribute.
When using the Fog attribute, the global “Fog” button will be activated within Handson.
If the fog generator also has a control channel for operating the fan then we recommend using a
“custom” part for this feature. Customs are described further in this chapter.
LAD
The LAD (Laser Aiming Device) control can be switched On by defning an On value.
The High End Systems Technobeam has a LAD.
Stand Alone
This can be used if a fxture has a stand-alone or sound activated mode.
This attribute functions as a switch; you can set an On value.
Display
This is used to switch of the display of your fxture during a show.
Barrel
The barrel can have two controls defned, Rotate CW and Rotate CCW.
Two examples of fxtures with a barrel:
Martin Destroyer or a Martin Wizard extreme.
Macro
Use the Macro part for controlling internal “programs” or “macros”.
You can add “On” for each Macro.
p 40