Bird Technologies SCC7 Series-Manual - Manual (Page 31)

17
5. Disconnect the sensor cable from the power sensor.
6. Loosen the 7/16 DIN connector nut that secures the RF cable to the sensor output on
the Cal Cart by turning it clockwise.
Note: DO NOT remove either the 7/16 DIN connector nut or RF cable yet.
7. Remove the screws on the sensor mounting bracket.
8. Remove the sensor from the mounting bracket.
9. Ensure the gasket remains attached to the mounting bracket.
10. Remove the 7/16 DIN connector nut and RF cable from the sensor output port.
Installing the Power Sensor
1. Install the new sensor into the sensor mounting bracket.
2. Ensure the arrow on the side of the sensor points towards the load, and that the end
labeled “SOURCE” points towards the front of the Cal Cart.
3. Connect the RF cable to the sensor end labeled “LOAD”.
Note: DO NOT tighten either the 7/16 DIN connector nut or RF cable yet.
4. Secure the sensor mounting bracket with the mounting screws.
5. Tighten the cable by turning it counterclockwise.
6. Connect the sensor cable.
7. Replace the Cal Cart front panel. See “Removing the Front Panel” on page 4.
Figure 10 Replacing the Sensor
WARNING
Care should be used when handling the RF cable and connector. DO NOT pull, pry, or tug on the RF cable or
connector. Otherwise, damage may occur to the cable housing and may cause a fire.
WARNING
Care should be used when handling the RF cable and connector. DO NOT pull, pry, or tug on the RF cable or
connector. Otherwise, damage may occur to the cable housing and may cause a fire.
Mounting
Bracket
Gasket
Mounting
Screws
RF Cable
7/16 DIN
Connector
Sensor
TOP VIEW ISOMETRIC VIEW
Mounting
Screw Mounting
Screw
Sensor
Mounting
Bracket
RF Cable
7/16 DIN
Connector
Sensor
Cable