Bird Technologies AT-500-Manual - Manual (Page 47)

Measure Match
29
Recalling a Trace
Follow the steps below to recall a saved trace.
1. Press the MENU key.
2. Press the SWEPT FREQ key.
3. Press the TRACE key.
4. Press the RECALL TRACE key.
5. Press the REG-n key for the desired trace, press
the MORE RECALL key to access 5-8 and again
to access 9-12. If needed, use the ESC key to back
up. The saved trace will be displayed and the cor-
responding register number will be shown at the
bottom of the display.
Note:
The arrow keys can be used to move
the cursor, and the corresponding measure-
ment and frequency at the cursor will be dis-
played. Remember the up arrow key will move
the cursor to the highest value on the trace and
the down arrow key will move it to the lowest.
z Press the RETURN key to return to register
selection.
z Press the ESC key to return to trace menu.
Clearing a Trace
When a trace is no longer needed or you need to clear
registers for space, follow the steps below.
1. Press the MENU key.
2. Press the SWEPT FREQ key.
3. Press the TRACE key.