Bird Technologies AT-500-Manual - Manual (Page 31)

Basic Operations
13
1. Press the MENU key.
2. Press the UTIL key.
3. Press the PRESET key.
Set Serial Baud Rate
Measurement data can be transferred between the
AT-500 and a personal computer using the serial port
and optional interface software. The data can then be
used for analysis, printed, or stored.
The data transfer rate (baud rate) between the
Antenna Tester and computer must be identical and
set to 9600. To change the baud rate for the serial port
on the Antenna Tester, follow the steps below.
Complete interface software instructions are included
with the software.
1. Press the MENU key.
2. Press the UTIL key.
3. Press the SERIAL key.
4. Repeatedly press the SERIAL key until the 9600
is displayed.
Software Parameter Factory Setting
Mode Swept Frequency
Start 2.0MHz
Stop 136.0MHz
Measurement Units VSWR
Scale min. 1.0; max. 5.0
Sweep Type Continuous
Limit Value 1.5
Limit Audio ON
Baud Rate 9600
Auto Shut-off Timer 5
Audio ON
Cursor 67MHz