Autocue SSP07 Quick Start - Manual (Page 5)

Getting started
- Prepare and connect the prompting hardware
SSP07-QStartUserManual.docx 2010-10-01
4
6.
Attach the tripod camera mounting plate to the
SSP07 unit.
7.
Slide the on-camera unit onto your tripod.
8.
Loosen the two thumbscrews holding the monitor and hood assemblies.
9.
Rotate the monitor assembly
10.
Raise the hood assembly to the vertical position and tighten the thumbscrews.
Note: The hood mounting bracket should fit over the
position.
Prepare and connect the prompting hardware
5
5
Attach the tripod camera mounting plate to the slider plate on the underside of the
camera unit onto your tripod.
Loosen the two thumbscrews holding the monitor and hood assemblies.
Rotate the monitor assembly so that the monitor is horizontal.
Raise the hood assembly to the vertical position and tighten the thumbscrews.
bracket should fit over the drop bracket and hold it securely in
© 2003-2010 Autocue Group Ltd.
underside of the
Raise the hood assembly to the vertical position and tighten the thumbscrews.
it securely in