AJA FS1 Version 2.2.0.47 User Manual
Installation and operation guide
Table of contents
Document Outline
- FS1 Guide Title Page
- Trademarks
- Notice
- FCC Emission Information
- Contacting Support
- Limited Warranty
- Important Safety Information
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Controls and Indicators
- Chapter 3: Installation & Configuration
- Chapter 4: Parameter Menus
- Controlling the FS1 via Front Panel Parameter Menus
- 1.1 Output Format
- 1.2 SDI 2 Out Format
- 1.3 Component Out
- 2.1 Video Input
- 2.2 Audio Input
- 2.11 Audio Map Ch1
- 2.12 Audio Map Ch2
- 2.13 Audio Map Ch3
- 2.14 Audio Map Ch4
- 2.15 Audio Map Ch5
- 2.16 Audio Map Ch6
- 2.17 Audio Map Ch7
- 2.18 Audio Map Ch8
- 2.21 Audio Map Ch 1/2
- 2.22 Audio Map Ch 3/4
- 2.23 Audio Map Ch 5/6
- 2.24 Audio Map Ch 7/8
- 3.1 Component In Format
- 3.2 Component Out Format
- 3.3 Frame Rate
- 3.4 NTSC Standard
- 4.1 Analog Audio Std
- 4.2 Audio Delay (mS)
- 4.3 Embed Audio Out
- 4.4 Sample Rate Convert
- 4.5 Audio Follow Video
- 4.6 AFV Memory
- 5.1 Upconvert Mode
- 5.2 Downconvert Mode
- 5.3 SD Aspect Ratio Convert
- 5.5 Downconvert AFD Default
- 5.6 AFD Out SDI 1
- 5.7 AFD Out SDI 2
- 6.1 Genlock Source
- 6.2 Output Timing H
- 6.3 Output Timing V
- 6.4 Analog Output Fine (Horizontal Timing)
- 7.1 Sidebar Keyer
- 7.2 Sidebar Edge
- 10.1 Proc Amp
- 10.2 Proc Amp Gain
- 10.3 Proc Amp Black
- 10.4 Proc Amp Hue
- 10.5 Proc Amp Sat
- 11.1 Loss of Input
- 20.0 Audio Output Levels
- 20.1 Audio Level Ch1
- 20.2 Audio Level Ch2
- 20.3 Audio Level Ch3
- 20.4 Audio Level Ch4
- 20.5 Audio Level Ch5
- 20.6 Audio Level Ch6
- 20.7 Audio Level Ch7
- 20.8 Audio Level Ch8
- 21.0 Audio Output Phase
- 21.1 Audio Phase Ch1
- 21.2 Audio Phase Ch2
- 21.3 Audio Phase Ch3
- 21.4 Audio Phase Ch4
- 21.5 Audio Phase Ch5
- 21.6 Audio Phase Ch6
- 21.7 Audio Phase Ch7
- 21.8 Audio Phase Ch8
- 30.1 Closed Captioning Translator
- 31.1 Upconvert Line 21
- 35.1 Remote Control
- 35.3 Authentication
- 36.1 GPI IN 1 Response
- 36.2 GPI IN 2 Response
- 37.1 GPI 1 OUT
- 37.2 GPI 2 OUT
- 40.1 Freeze Output
- 41.2 Video SG
- 41.3 Audio SG
- 50.1 IP Config
- 50.2 IP Address
- 50.3 Subnet Mask
- 50.4 Default Gateway
- 50.5 System Name
- 50.6 MAC Address
- 51.1 SNMP Enable
- 51.2 SNMP Trap Destination 1
- 51.3 SNMP Trap Port 1
- 51.4 SNMP Trap Destination 2
- 51.5 SNMP Trap Port 2
- 60.1 Power Supply Alarm
- 60.2 Format Alarm
- 60.3 Reference Alarm
- 70.1 Screen Saver
- 70.2 Display Intensity
- 80.1 Serial Number
- 80.2 Software Version
- 90.0 Reboot
- 91.1 Preset Recall
- 92.1 Preset Save
- 99.0 Factory Settings
- Chapter 5: Browser Remote Control
- Remote FS1 Control Via a Web Browser
- General Screen Information
- Controlling Multiple FS1s
- Resetting Values To Factory Settings
- Audio and Video I/O Screen
- Audio Control Screen
- Convert Mode Screen
- Genlock Control Screen
- ProcAmp Control Screen
- Caption Screen
- Presets Screen
- Miscellaneous Screen
- Test Signals Screen
- Network Screen
- SNMP Screen
- Update Firmware
- Remote FS1 Control Via a Web Browser
- Chapter 6: SNMP
- Appendix A: Specifications
- Appendix B: GPI Connector Pinout
- Appendix C: Analog Audio Connector Pinout
- Appendix D: Safety & Compliance
- Federal Communications Commission (FCC) Compliance Notices
- Canadian ICES Statement
- European Union and European Free Trade Association (EFTA) Regulatory Compliance
- Korea KCC Compliance Statement
- Taiwan Compliance Statement
- Japanese Compliance Statement
- Translated Caution Statements, Warning Conventions and Warning Messages
- Before Operating Your FS1 Unit, Please Read the Instructions in This Document
- Appendix E: Glossary
- Index