1 - prepare the panelview plus terminal hardware, Before you begin, What you need – Rockwell Automation Logix5000 Control Systems: Connect PanelView Plus Terminals over EtherNet/IP Quick Start User Manual
Page 13: Chapter 1, Prepare the panelview plus terminal hardware, Before you begin what you need, Prepare the panelview, Plus terminal hardware, Chapter
Rockwell Automation Publication IASIMP-QS033A-EN-P - March 2012
13
Chapter
1
Prepare the PanelView Plus Terminal Hardware
In this chapter, you learn how to complete the following tasks:
•
Mount and wire power to a 2711P-K10C4D1 terminal.
•
Configure EtherNet/IP communication for the terminal.
Before You Begin
You must complete these tasks described in
Before Using This Publication on page 5
before using
this chapter:
•
Prepare the Logix5000 control system hardware
•
•
- The tasks described in this chapter require an
EtherNet/IP network.
•
Create an RSLogix 5000 project
The example RSLogix 5000 project used in this chapter uses a
CompactLogix 5370 L3 controller.
What You Need
This table lists the products you need to complete the tasks described in this chapter.
Quantity
Cat. No.
Description
1
2711P-K10C4D1
PanelView Plus terminal with built-in EtherNet/IP network port
1
2711P-RSACDIN
DC power supply for PanelView Plus terminals
1
Panel for mounting the terminal - Optional when using this publication
1
1585J-M8PBJM-2
RJ45-to-RJ45 patchcord Ethernet cables